retainers

英 [rɪˈteɪnəz]

美 [rɪˈteɪnərz]

n.  (聘请律师等的)预付费用，保留金; (为保留租房而付的)租房订金; 牙齿固位体; 保持器
retainer的复数

柯林斯词典

• N-COUNT 定金;预付金
  Aretaineris a fee that you pay to someone in order to make sure that they will be available to do work for you if you need them to.
  1. I'll need a five-hundred-dollar retainer...
     我将收取500美元的定金。
  2. Liz was being paid a regular monthly retainer.
     利兹每月得到一笔预付金。
• N-COUNT （服务多年的）仆人，家仆
  A servant who has been with one family for a long time can be referred to as aretainer.
  1. I found the gardener, a family retainer, morosely surveying the scene.
     我发现这个园丁——家里一个服侍多年的仆人，愁眉苦脸地审视着这个场景。

双语例句

• Retainers are made of brass, synthetic resins or others subject to individual bearing features and application conditions.
  保持架的材质有黄铜、合成树脂等，以轴承形式、使用条件而区分。
• Press the cowl top trim panel down until the snap clip retainers engage in the top of the instrument panel.
  向下压仪表板顶部饰板，直至夹扣定位器啮合到仪表板顶部。
• Loosen but do not fully remove the four bolts that attach the stabilizer bar bushing retainers to the rear axle brackets.
  松开但不完全拆卸接合稳定杆衬套扣环与后车轴支架的4支螺栓。
• CONCLUSION: Analysis for the health condition of abutment and its periodontal tissue is imperative for the selection of different designs of retainers.
  结论：应依据基牙与牙周组织的健康状况，选择最佳固位方式。
• The rear door scuff plate is attached with molded-in snap retainers.
  后车门框板由模制紧压保持器连接。
• Engage the heater-A/ C wire harness connector and blower motor relay wire harness connector push-in retainers with their mounting holes in the heater-A/ C housing.
  将加热器-空调电线束接头和鼓风马达继电器电线束接头推入扣件与它们加热器-空调外壳里的固定孔啮合。
• Evaluation of corrosion resistance of magnetic retainers with two different metals
  2种不同金属磁性固位体耐腐蚀性的评价
• Disconnect the power mirror wire harness retainers from the inner door panel.
  从内侧车门饰板断开电动视镜电线束扣件。
• The swashbuckling style of News International was rooted in an age when proprietors told politicians what to do, journalists did what they liked, and police officers were on cash retainers.
  新闻国际那种霸道的行事作风形成于一个新闻业老板对政客发号施令、记者对老板唯命是从、警察则贪财忘义的时代。
• All Retainers used to locate trim punches and sections, punches and buttons must be hardened and ground.
  所有的固定器一般用于定位剪切冲头及不见，冲头及嵌套必须被热处理及研磨。