pawl
英
美
网络 棘爪; 制转杆; 掣爪; 卡爪
复数：pawls
英英释义
noun
- a hinged catch that fits into a notch of a ratchet to move a wheel forward or prevent it from moving backward
双语例句
- Design characteristics of pawl pole permanent synchronous machine
爪极永磁同步电机的设计特点 - The pipe tongs is mainly composed of a fixed jaw, a movable jaw, a racket wheel, a spring, a pawl, a movable pin and a connecting pin;
主要由固定钳口、活动钳口、棘轮、弹簧、棘爪、活动销和连接销等组成。 - If the cup plug is missing, the park pawl anchor shaft can move out of position under certain conditions.
如果该杯状固定塞脱落，驻车止动爪定位销可能在特定情况下滑移出正常位置。 - The virtual prototype of the clutch is built based on Pro/ E and the switch process of the SSS clutch is simulated by MSC Adams. The simulation of the impact performance of the pawl and pawl wheel and the engaging performance of the middle part is finished.
利用Pro/E及MSCADAMS建立该离合器的虚拟样机模型，并在MSCADAMS中对离合器动态接合过程进行仿真，分析棘轮棘爪的碰撞特性，以及中间件的啮合特性。 - The pawl type bamboo roots grab was designed.
竹爪式竹根挖掘机方案设计。 - Tyre-lock chain interlocking pawl ( winding) wheel
胎锁链（轮胎防滑）大钢轮，互锁棘爪轮 - The indexing pawl advances a fastener into operative engagement with the feed pawl upon movement of the second canister portion from the open position to the closed position.
当第二筒部从打开位置移动到关闭位置时，分度棘爪使紧固件前进并使其与进给棘爪工作啮合。 - Ratchet mechanism is often used in the reducer of the casting crane. This paper uses Pro/ ENGINEER software to create the ratchet mechanism and simulate its running and studies the stress and deformation of the ratchet wheel pawl by Pro/ MECHANICA.
针对铸造起重机用减速器常采用的棘轮装置，采用三维实体造型软件Pro/ENGINEER建立其实体模进行运动仿真，利用Pro/MECHANICA有限元分析模块对棘爪进行应力、应变分析，得到棘爪需加强的部分。 - The fine blanking dies of the pawl and the chute used for the seat recliner were firstly introduced in this thesis, and failure analysis has been carried out in view of mechanical calculation, metallographic test, hardness test and SEM.
本文首先针对棘爪、滑槽板两副精冲模具出现断裂的凸模，从力学强度校核、金相试验、硬度试验、断口电镜扫描等进行试验分析。 - The blades are positioned on the large handle by a rotating shaft screw, and the pushing pawl and a pawl torsion spring are connected with the small handle through the pawl pin.
小手柄上通过棘爪销柱连接有推进棘爪及棘爪扭簧，推进棘爪受到棘爪扭簧的压力始终压制在刀片的齿上；