chamfer
英 [ˈtʃæmfə(r)]
美 [ˈtʃæmfər]
n. 斜切面; 削角
复数：chamfers 现在分词：chamfering 过去分词：chamfered 过去式：chamfered 第三人称单数：chamfers
COCA.44768
牛津词典
noun
- 斜切面；削角
a cut made along an edge or on a corner so that it slopes rather than being at 90˚
英英释义
noun
verb
双语例句
- Select those front edges and chamfer them then click apply and chamfer it again but this time with a lower value.
选择前面的边并倒角，然后单击应用并以较低的值再次倒角。 - CHAMFER: The flat surface formed by cutting away the sharp edges of two meeting surfaces.
倒角：两个表面相交处，通过切掉尖锐边缘形成的平面。 - Fit the sealing ring at the correct position in the vacuum pump so that it is flush with the lower edge of the chamfer in the rotor.
将密封圈安装在真空泵的正确位置，以便密封圈与转子倒棱的下边缘平齐。 - In order to miniaturize the millimeter wave circuit system, this study improved the traditional chain SIW filter and brought forward a new type of compact configuration with chamfer angle.
为了实现毫米波电路系统小型化，对传统链式SIW滤波器进行改进，提出了一种新型的带倒角的紧缩结构SIW滤波器。 - Carefully remove smaller edges or burrs on the chamfer of the crankshaft flange with an oilstone if necessary.
如有必要，请用油石仔细去除曲轴法兰倒棱上的小边或毛刺。 - The effects of rolling parameters such as plate width, roll contours, chamfer and straight chamfer parameters on the contact pressure distribution were studied.
研究结果表明，在轧制能力范围内，轧件越宽，轧辊采用凹辊型可以使辊身部的辊间压力分布更为均匀； - If you need the capability study on the big chamfer for300 pcs, then we have to measure at CMM ( 3D) as GFT method.
如果您需要300个大倒角能力的研究，那么我们在三坐标测量机（3D）测量GFT的方法。 - Programming Method of Milling of Chamfer and Fillet Based on$ TC_DP
基于＄TCDP铣削斜面及倒圆角的程序编制方法 - The specialized inspector inspects the bore diameter, pitch, chamfer and finish degree of bore wall.
加工完成后由专门检验员检验孔径、孔距、倒角大小、孔壁光洁度。 - But for Reminder: the dimensions related to big chamfer are not major characteristic.
但提醒：大倒角的尺寸并不大特点。